Programming Instructions - GEOSATpro DVR1000ci PVR
GEOSATpro DVR1000ci PVR
FTA Satellite Receiver Programming
This guide will assist in programming your receiver to enable reception of many other Free To Air ( FTA ) broadcasters. Before attempting to program new channels it may be necessary to make adjustments to the dish and/or LNBF to obtain a strong signal that reflects good signal and quality levels. Poor signal quality will affect the ability to program and properly receive additional channels. Adding New Transponder Information
On Satellite AMC-4
- Using the remote control, press the Menu key
- Go to INSTALLATION, press the Enter key
- Enter Passcode 0000
- Go to TP Edit / Scan, press the Enter key
- Highlight SATELLITE NAME, press the VOL (Right or Left) Arrow key to select the satellite. (i.e.AMC4 Ku for ATN / LifeTalk )
- Go to TP FREQUENCY, press the VOL (Right or Left) Arrow key to select the frequency or enter the frequency (i.e.11983 for ATN / LifeTalk )
- Go to POLARIZATION press the VOL (Right or Left) Arrow key to select the polarity (Horizontal for ATN / LifeTalk)
- Go to SYMBOL RATE, enter the symbol rate ( i.e. 5900 for ATN / LifeTalk )
- Go to SCAN , press the VOL (Right or Left) Arrow key to FREE only, press OK
- Upon completion of the scan press EXIT several times until the receiver displays "Saving Changes Please Wait"
In a moment, the receiver will reset and display all channels . Repeat the above steps to program additional channels
